Cisco RNG150 User's Guide download pdf (Page 10)

RNG150N / RNG200N USER GUIDE (501-3339201) B949/B950

CONNECTING THE EQUIPMENT (cont.)

WARNINGS

Do not connect your set-top (or any other equipment such as a TV or VCR) to the power supply until you

have properly connected all the other cables.

Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades

with one wider than the other. A grounding type plug has two blades and a third grounding prong. The

wide blade or the third prong are provided for your safety.

Connecting the power supply unit to your set-top

Before you insert the power supply unit into the wall AC outlet, connect the 12 volt DC cord from the power

supply unit to the socket labeled “DC IN

12 V” on your set-top’s rear panel.

Connecting equipment to the wall AC outlets

Connect your set-top’s power supply unit, and the plugs on the power cords from your TV, VCR, and any other

equipment, into wall AC outlets. If these outlets have switches, switch them ON.

Turning your set-top on and off

After you have connected your set-top’s power supply unit to the wall AC outlet (and switched this outlet ON,

if it has a switch), press the POWER button on your remote control to turn your set-top on (making sure your

remote control is set to control your set-top). The (power) light on your set-top’s front panel should light up

green, to show that your set-top is on.

To turn your set-top on or off at any time, press the POWER button on your remote control.

Never turn off your set-top by simply disconnecting it from the power supply. If you need to disconnect your

set-top, ﬁrst stop any recording (if applicable). Then turn off your set-top by pressing the POWER button on

your remote control, so that the (power) light goes off. Then wait 60 seconds before removing the power

supply unit from the wall AC outlet.

Power Saving: To save power and money, and to reduce greenhouse gas emissions, turn off

your set-top, using the POWER button on your remote control, when it is not in use.

Lightning storms

Disconnect your set-top’s power cord during lightning storms. A lightning storm may affect your set-top, if it

is on during the storm. It may appear that it has stopped working, but you can easily restore its operation as

follows:

Unplug your set-top’s power supply unit from the wall AC outlet. Then plug this power supply unit in again at

the wall AC outlet (and, if there is a switch by this outlet, switch it to its ON position).

Using your remote control

Your cable TV service-provider determines the digital channels, services, and screen information that you see

on your TV when you use your set-top and its remote control.

Consult the information supplied by your cable service-provider for details on how to make the most of the

digital cable services. Also read the operating instructions that are supplied with your remote control.

NOTE

IMPORTANT: Unless there is a

lightning storm or you will be

away from your home for a long

time, do not unplug your set-top’s

power supply unit at the wall AC

outlet (or do not switch it off there,

if the outlet has a switch). Your

set-top cannot be updated with

new features, through the cable, if

it is disconnected from the power

supply.

The (power) light

lights up green.

Front panel display, showing

the time (see page 23)

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

Comments to this Manuals

No comments

Cisco RNG150 User's Guide Page 10

Comments to this Manuals

Related products and manuals for Digital Video Recorders (DVR) Cisco RNG150