Cisco Unified 7900 Series User Manual download pdf (Page 4)

Interoperability between Cisco Unified IP 7900 Series phones and ProCurve switches

HP ProCurve Networking

1. To view the power consumption of the phone, issue the following command on the switch:

show power-over-ethernet X

Where X is the port on which the phone is plugged.

2. On a 2610 switch, the command is:

show power-management X

For a Cisco Unified IP Phone 7971G this consumption is around 7.5 watts (Power Class 3):

ProCurve Switch 2610-24/12PWR# sh power-management 2

Status and Counters - Port Power Status for port 2

Power Enable : Yes

Priority : Low Configured Type :

Detection Status : Delivering Power Class : 3

Over Current Cnt : 0 MPS Absent Cnt : 0

Power Denied Cnt : 0 Short Cnt : 0

Voltage : 466 dV Current : 162 mA

Power : 7541 mW

4. Configuring QoS support

This section explains how to configure Quality of Service parameters.

4.1 Configure QoS on the Cisco phone

To configure QoS on the Unified IP Phone 7971G, use Cisco Unified Call Manager. The QoS Configuration Menu

options are the following:

• DSCP for Call Control: DSCP IP classification for call control signaling

• DSCP for Configuration: DSCP IP classification for any phone configuration transfer

• DSCP for Services: DSCP IP classification for phone-based services.

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Cisco Unified 7900 Series User Manual Page 4