Cisco AIR-ANT2513P4M-N= Datasheet download pdf (Page 12)

Cisco Aironet Four-Port Dual-Band Polarization-Diverse Antenna (AIR-ANT2513P4M-N)

78-21447-01

Installing the Antenna

Figure 6 Assembling the Bracket Hardware

Step 5

Make sure you orient the antenna correctly (note the arrow on the back of the antenna that indicates the

top of the antenna). Use a 1/2 in. (13-mm) wrench to loosen the elevation adjustment bolt and the

elevation pivot bolt.

Step 6 Adjust the azimuth (side-to-side position) and elevation (up-and-down position) of the antenna. Loosen

the adjustment bolts slightly to allow for adjustment. Azimuth angle can be adjusted ±25 degrees and

elevation can be adjusted ±60 degrees. You can use the azimuth and elevation markings on the mounting

arm and the wall flange as a guide.

Step 7 After you adjust the antenna position, tighten the adjustment bolts and the pivot bolts. Tighten all bolts

to 18.7 +/- 5 lb-ft (25.4 Nm).

Step 8 Connect the antenna cables to the access point. The antenna ports are labeled A through D, from left to

right. Connect the antenna port A to connector A on the access point, antenna port B to connector B, and

so on. See the Suggested Cable section for cable recommendations.

1 2 ... 7 8 9 10 11 12 13 14

No comments

Cisco AIR-ANT2513P4M-N= Datasheet Page 12