Cisco 1900 series Specifications download pdf (Page 16)

Connecting to the Console Port

Catalyst 1900 Series Installation and Configuration Guide

2-16

Connecting to the Console Port

Note The rollover console cable and a RJ-45-to-DB-9 female DTE adapter are supplied.

If your management station requires a different adapter—such as a RJ-45-to-DB-25 female

DTE or RJ-45-to-DB-25 male DCE adapter—you must provide it. For pinout information,

see the “Console Port” section on page B-6.

To connect the switch RJ-45 console port to a management station or modem, you must use

the supplied RJ-45-to-RJ-45 rollover console cable and the appropriate adapter and follow

these steps:

Step 1 Make sure the settings of the switch console port and the management station or

the modem match.

These are the default settings of the switch console port:

• 9600 baud

• 8 data bits

• 1 stop bit

• No parity

• No ﬂow control

Although the Match Baud Rate option (autobaud) matches the baud rate of an

incoming call, the switch uses its conﬁgured rate when dialing out. When a call

is completed and the line disconnects, the switch always returns to its conﬁgured

baud rate.

You can change the console port settings from the Console and Upgrade

Conﬁguration Page (see the “Changing the Console Port Settings and Upgrading

the Firmware” section on page 3-59) or the RS-232 Port Conﬁguration Menu

(see the “RS-232 Interface Conﬁguration Menu” section on page 4-74).

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 43 44

No comments

Cisco 1900 series Specifications Page 16