Cisco 2516 User Manual download pdf (Page 21)

Release Notes for Cisco IOS Release 11.2(11) Software Feature Packs for Cisco 2500 Series Routers 21

Installing the Router Software Using a TFTP Server Application

Step 14 In response to the following prompt, enter the destination ﬁlename, and press Enter.

Destination file name [cpa2500-upgrade-l.112-3.P]?

cpa2500-upgrade-l.112-3.P

(This is the name of the image ﬁle on the router, not the full pathname of the image on

the PC CD-ROM.)

During the transfer process, messages indicate that the software has accessed the ﬁle you

have speciﬁed and is loading it.

If the ﬁle is not found, check the following:

• The ﬁlename is correct.

• The TFTP server is enabled.

• The correct root directory is selected.

• There is IP connectivity between the router and TFTP server.

If the ﬁle is still not found, create a temporary directory called C:\temp and copy the

CiscoPro upgrade ﬁle into the directory. Select the C:\temp directory as the root directory.

Step 15 Enter yes in response to the prompt asking if you want to erase the existing image in the

router Flash memory before copying the new one:

Erase flash device before writing? [confirm] yes

The entire copying process takes several minutes and differs from network to network.

The exclamation point (!) indicates that the copy process is taking place. Each

exclamation point indicates that ten packets have been transferred successfully. If you see

three or more periods (...), the transfer might fail. If the transfer fails, check IP

connectivity between the router and TFTP server by using the ping command.

Step 16 Enter the reload command to reload the router:

Router(boot)# reload

Do not save the conﬁguration.

After reload is complete, your CiscoPro router has been upgraded to a Cisco Enterprise

router. Because the original Cisco IOS image that resided in Flash memory was erased

during the upgrade process, the router should now be running in bootstrap mode.

Step 17 If the password prompt appears, enter the password.

Password:

Step 18 At the router prompt, enter enable and then the password:

Router(boot)# enable

Password:

Step 19 At the router prompt, enter the following command to copy the new software image from

the PC CD-ROM drive to the router:

Router(boot)(config)# copy tftp flash

In the next series of steps, you download the Cisco IOS Release 11.2 images that you

want installed on your router.

Step 20 When prompted, enter the IP address of your PC, as in the following example:

Address or name of remote host [255.255.255.255]? 131.108.1.1

This is the IP address of your local PC, not that of the router.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26

Comments to this Manuals

No comments

Cisco 2516 User Manual Page 21

Comments to this Manuals

Related products and manuals for Networking Cisco 2516