Cisco 3620 Installation Guide download pdf (Page 23)

You may see different startup messages:

• If you see the following messages, the router has booted with a configuration file and is ready for initial configuration using

the Cisco Router and Security Device Manager (SDM):

yourname con0 is now available

Press RETURN to get started.

See the “Initial Configuration Using Cisco Router and Security Device Manager” section on page 24 to learn how to

configure your router using SDM or to learn how to obtain SDM and install it on your router.

• If you see the following messages, the router has booted and is ready for initial configuration using the setup command

facility or the command-line interface (CLI).

--- System Configuration Dialog ---

At any point you may enter a question mark '?' for help.

Use ctrl-c to abort configuration dialog at any prompt.

Default settings are in square brackets '[]'.

Would you like to enter the initial configuration dialog? [yes/no]:

To learn how to use the Setup Command Facility to configure the router, see the “Initial Configuration Using the Setup

Command Facility” section on page 27. To learn how to use the CLI to configure the router, see the “Initial Configuration

Using the CLI (Manual Configuration)” section on page 30.

Note If the rommon 1> prompt appears, your system has booted in ROM monitor mode. For information on the ROM

monitor, see the router rebooting and ROM monitor information in the Cisco IOS Configuration Fundamentals

Configuration Guide for your Cisco IOS software release.

You can access this document at the locations described in the “Where to Go Next” section on page 32.

6 Perform Initial Configuration

You can configure your router by using one of the following methods:

• Cisco Router and Security Device Manager (SDM)—If your router was purchased with a VPN bundle, SDM is installed on

the router. For instructions on configuring your router by using SDM, refer to the Cisco Router and Security Device

Manager (SDM) Quick Start Guide that shipped with your router. See the “Initial Configuration Using Cisco Router and

Security Device Manager” section on page 24 for additional information.

• Setup command facility—You can use the setup command facility to configure basic router information. After the

configuration file has been created, you can use the CLI or SDM to perform additional configuration. See the “Initial

Configuration Using the Setup Command Facility” section on page 27 for additional information.

• Command-line interface (CLI)—If you prefer to use the Cisco IOS CLI, see the “Initial Configuration Using the CLI

(Manual Configuration)” section on page 30 for instructions on how to use the CLI.

Note You need to understand how interfaces are numbered so that you know which interface you are configuring. If you need

help with interface and port numbering, see the “Interface Numbering” section on page 31.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 35 36

No comments

Cisco 3620 Installation Guide Page 23