Cisco CX-FEIP-2TX= Installation and con?guration Specifications download pdf (Page 24)

24 Second-Generation Fast Ethernet Interface Processor (FEIP2) Installation and Conﬁguration

FEIP2 Installation

Removing an FEIP2

You need not shut down the interface or the system power when removing an FEIP2 or interface

processor.

Note In Cisco 7507 or Cisco 7513 systems, online insertion and removal of any interface processor

in either CyBus might cause the slave RSP2 to reboot with a bus error or a processor memory parity

error. The master RSP will recover from this event and issue a “cBus Complex Restart” message.

Cisco 7507 and Cisco 7513 systems that are conﬁgured with an RSP4 as the system slave are not

affected and will not experience this problem.

If you have a Cisco 7507 or a Cisco 7513 with an RSP2 conﬁgured as the system slave, we strongly

recommend that you use the following procedure to remove and replace an interface processor:

Step 1 Remove the slave RSP2.

Step 2 Wait 15 seconds.

Step 3 Remove and replace the interface processor using the procedures in this publication.

Step 4 Wait 15 seconds.

Step 5 Reinsert the slave RSP2.

If you are replacing a failed FEIP2, remove the existing board ﬁrst, then install the new FEIP2 in the

same slot. If you are replacing a currently installed interface processor with an FEIP2, remove the

existing board ﬁrst, then install the new FEIP2 in the same slot.

Figure 18 shows proper handling of an interface processor during installation.

Figure 18 Handling Processor Modules for Installation and Removal (Horizontal Orientation Shown)

H4714

Captive installation

screws

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 41 42

No comments

Cisco CX-FEIP-2TX= Installation and con?guration Specifications Page 24