PA-T3 and PA-2T3 Serial Port Adapters 1PA-T3 and PA-2T3 Serial Port AdaptersDescriptionThe PA-T3 and PA-2T3 serial port adapters are available on Cis
Command Reference10Release 11.1 CAinvert dataTo invert the data stream, use the invert data interface configuration command. This command applies only
loopback PA-T3 and PA-2T3 Serial Port Adapters 11loopbackTo loop the serial interface on a PA-T3 port adapter, use the loopback interface configuratio
Command Reference12Release 11.1 CAscrambleTo enable scrambling of the payload on the PA-T3 port adapter, use the scramble interface configuration comm
show controllers cbus PA-T3 and PA-2T3 Serial Port Adapters 13show controllers cbusTo display all of the current interface processors and their interf
Command Reference14Release 11.1 CA IOS (tm) VIP Software (SVIP-DW-M), Experimental Version 11.1(4430)[gshen 108] ROM Monitor version 17.0 Mx T
show controllers serial PA-T3 and PA-2T3 Serial Port Adapters 15show controllers serialUse the show controllers serial privileged EXEC command to disp
Command Reference16Release 11.1 CAshow diagTo display hardware information for an interface, use the show diag privileged EXEC command on Cisco 7500 s
show interfaces serial PA-T3 and PA-2T3 Serial Port Adapters 17show interfaces serialTo display information about a serial interface, use the show int
Command Reference18Release 11.1 CATable 2 describes significant fields shown in the display.Table 2 Show Interfaces Serial Field Descriptions Field De
show interfaces serial PA-T3 and PA-2T3 Serial Port Adapters 195 minute input rate5 minute output rateAverage number of bits and packets transmitted p
Configuration Tasks2Release 11.1 CAConfiguration TasksPerform the tasks in the following sections to configure the PA-T3 (all tasks are optional excep
Supported MIB20Release 11.1 CASupported MIBThe PA-T3 port adapter supports a subset of RFC 1407 MIB. We support DS3 Near End Group including—DS3/T3 Co
Troubleshoot the PA-T3 Port Adapter PA-T3 and PA-2T3 Serial Port Adapters 3Troubleshoot the PA-T3 Port AdapterTo set the following loopbacks to troubl
Configuration Example4Release 11.1 CAConfiguration ExampleThe following example shows a typical configuration for serial interface 1/0/0 on a PA-T3 se
cablelength PA-T3 and PA-2T3 Serial Port Adapters 5cablelengthTo change the length of the cable, use the cablelength interface configuration command.
Command Reference6Release 11.1 CAclock sourceTo control which clock a T3 interface or a PA-T3 serial port adapter will use to clock its transmitted da
dsu bandwidth PA-T3 and PA-2T3 Serial Port Adapters 7dsu bandwidthTo specify the maximum allowable bandwidth used by the PA-T3 port adapter, use the d
Command Reference8Release 11.1 CAdsu modeTo specify the interoperability mode used by the PA-T3 port adapter, use the dsu mode interface configuration
framing PA-T3 and PA-2T3 Serial Port Adapters 9framingTo specify T3 line framing used by the PA-T3 port adapter, use the framing interface configurati
Comments to this Manuals