Cisco AS5300 Chassis Installation Guide – Overview Table Of Contents Overview Chassis Components Cards Quad T1/PRI and E1/PRI Cards Quad Cards Withou
The DSP module provides voice compression and packetization services to the VoIP card so that you can configure and expand them. • 6 DSPs per DSP mod
current Typical input current Efficiency Input DC power 63% 200 to 400W4 (maximum) Protection Output voltage Output voltage Output voltage Output vo
Chassis Components The chassis consists of the following components: • One 19-inch modular chassis with a high-speed backplane and three slots for a
Cards The chassis includes three card slots (see ) in which you can install a combination of cards. In any single slot you can install your choice
Cards Module Memory Requirements Octal T1/PRI or E1/PRI DMM 64 MB (upgrade included) Quad T1/PRI or E1/PRI with serial ports HMM 32 Meg Qua
The Quad E1/PRI WAN card (see ) without serial interfaces includes four RJ-45 ports for terminating 120-ohm balanced lines or 75-ohm unbalanced lines.
"T1/PRI and E1/PRI Cards" in the Cisco AS5300 Universal Access Module Installation Guide for details. Cables are not included with the card
6-Port Module Cards Each 6-port module includes 6 modems. Therefore, in a fully populated MICA card, you can have up to 60 modems. Or, in a fully pop
The modules connect through the Microcom carrier card and the system backplane to a Quad or Octal T1/PRI or E1/PRI card installed in the access serve
Voice-over-IP (VoIP) Card The VoIP card is a coprocessing card and software package that adds VoIP capabilities. The VoIP capability enables a Cisco
Comments to this Manuals