Cisco TelePresence MSE 8710 Specifications download pdf (Page 5)

Installing the Cisco TS MSE 8710

Step one: Install the Cisco TS MSE 8710 blade into the MSE 8000

1 Remove the blade or blanking blade from the slot into which you are going to

install the Cisco TS MSE 8710:

i Using a No. 1 Phillips screwdriver, loosen the screws in the retaining

latches with an anti-clockwise quarter turn.

Important: Before installing the Cisco TS MSE 8710 into the MSE 8000,

read the safety information guide for the MSE 8000 chassis at

http://www.cisco.com/go/telepresence/safety

Although blades are hot-swappable parts, you must only remove one

blade at any time. Remove the power from the MSE 8000, if you need to

remove more than one blade at a time.

Before hot-swapping a blade, shut down the blade using the web

interface. Do not shut down a blade during a software upgrade or if the

blade is processing (for example, if a conference is taking place on a

Server blade blade).

The MSE 8000 backplane uses high performance data connectors. Do not

remove Cisco TS MSE 8710 blades unless absolutely necessary because

doing so may reduce the life of those connectors.

Make sure that you have the correct power requirements and sufficient

power in your PSU; for information on powering the MSE 8000 refer to

the Getting Started Guide on http://www.tandberg.com/support/video-

conferencing-documentation.jsp).

You must install either a blade or a blanking blade in each of the ten

positions in the chassis.

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Cisco TelePresence MSE 8710 Specifications Page 5