© 2011 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information. Page 25 of 28
RAID Controller Notes
The LSI MegaRAID Controller can be installed in the low-profile PCIe slot. The SAS riser card supports up to 16
SAS/SATA drives.
The LSI MegaRAID card (LSI
®
6G MegaRAID SAS 9261-8i) supports the following features:
●
Form factor: PCIe low-profile (H x L) = 2.536 x 6.60 inches
●
LSI SAS2108 (Liberator) ROC (RAID-On-a-Chip) Controller, at 800MHz
●
x8 PCI Express 2.0 host interface
●
Two internal Mini SAS SFF-8087 x 4 connectors (horizontal mount)
●
Eight channels of SAS/SATA at up to 6 Gbps
◦ SAS rates of 6.0 Gbps and 3.0 Gbps
◦ SATA rates of 3.0 Gbps and 1.5 Gbps
●
Hardware RAID (levels 0, 1, 5, 6, 10, 50 and 60)
●
Supports drive hot-plugging
●
5-Chip DDR2 on-board memory running at 800 MHz (64-bit with error-correcting code ECC) for enhanced
hardware RAID performance
●
512 MB on-board DDR2-800 cache arranged as 64Mx16 devices (1 Gb capacity)
●
iBBU support: direct connected iBBU07 RAID Battery Back-up module for DDR2 DIMM refresh support
during a power failure
●
8-MB CFI Compliant Flash ROM and a 32 kB NVSRAM (nonvolatile SRAM) for disk and drive setup
information storage
●
System Enclosure Specification (SES) connectivity through I
2
C cable or SGPIO
Refer to LSI
®
MegaRAID SAS 9261-8i Product Specification or visit the link below for a detailed description of this
board:
http://www.lsi.com/storage_home/products_home/internal_raid/megaraid_sas/value_line/megaraid_sas_9261-
8i/index.html.
The LSISAS1064E Controller-based mezzanine card can be installed in the mezzanine slot on a Cisco UCS C210
M2 server. The mezzanine card supports up to 4 SAS/SATA drives.
Contents: Overview Detailed Views Base Unit Features Configuring Memory HDD
Option Cards RAID Software Services Memory Notes
PCIe Slot Notes SAS Extender/Expander Notes RAID Controller Notes
Physical Specs Power Specs Environmental Specs
Comments to this Manuals