Cisco ATA188-I2 User Manual

Browse online or download User Manual for Telephones Cisco ATA188-I2. Cisco ATA186 and Cisco ATA188 1 Important Notes 2

  • Download
  • Add to my manuals
  • Print
  • Page
    / 6
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
Cisco ATA186 and Cisco ATA188
1 Important Notes
Check the SIP 3
rd
Party Validation Website for current validation status.
The SIP 3
rd
Party Component Validation Website can be viewed at:
http://www.testlab.inin.com
The difference between the ATA186 and the Cisco ATA188 is that the
ATA188 has an internal Ethernet switch.
The ATA 186/188 does not support two ports using G.729 codec
simultaneously. The G.729 codec can only run on one port at a time.
If one port is using G.729, the other port can only use G.711. The
following combinations are allowed on the ATA 186/188:
1. Two simultaneous G.723 codecs
2. Two simultaneous G.711 codecs
3. One G.723 and one G.711 codec
4. One G.729 and one G.711 codec (G.729 is available on first-
come first-serve basics)
2 Vendor Documentation
CiscoATA186 Data Sheet
http://www.cisco.com/warp/public/cc/pd/as/180/186/prodlit/at186_ds.htm
CiscoATA188 Data Sheet
http://www.cisco.com/warp/public/cc/pd/as/180/186/prodlit/at188_ds.htm
Firmware upgrades:
http://www.cisco.com/cgi-bin/tablebuild.pl/ata186
Directions for downloading firmware to the ATA186 (note that the manual
method, using the program ata186us.exe, works well):
http://www.cisco.com/en/US/products/hw/gatecont/ps514/products_admi
nistration_guide_chapter09186a00800c4d1d.html#40915
Information about faxing:
http://www.cisco.com/en/US/products/hw/gatecont/ps514/products_admi
nistration_guide_chapter09186a00801e0e66.html#63198
3 Versions Verified
Supported Version: 3.2.1
Page view 0
1 2 3 4 5 6

Summary of Contents

Page 1 - 3 Versions Verified

Cisco ATA186 and Cisco ATA188 1 Important Notes • Check the SIP 3rd Party Validation Website for current validation status. The SIP 3rd Party Com

Page 2 - 6 Configuration

4 Install Firmware upgrades can be found at: http://www.cisco.com/cgi-bin/tablebuild.pl/ata186 Directions for downloading firmware to the ATA186 (n

Page 3

address is 10.0.0.1 then type http://10.0.0.1/ to access the parameters. The IP address can be determined by following the steps outlined above. Sim

Page 4

according to your site’s specifications. AltGk Alternate or Backup Proxy. This is the IP address where the phone will send its requests if no syste

Page 5

Media Section LBRCodec Low-bit rate codec. The Cisco ATA 186 can support two simultaneous G.723 calls or one G.729A call. When using G.729A, the

Page 6

Call Forwarding (service enabled through phone) Forward Unconditional Press #72, the number you want to forward call to; then press # again Forward W

Comments to this Manuals

No comments