Model: SX80
Device Type: Video Conference
SIMPLWINDOWS NAME:
Cisco SX80
CATEGORY:
Conferencing
VERSION:
1.2
SUMMARY:
This module will control the Cisco SX80 video codec via RS232.
GENERAL NOTES:
This module will control the Cisco SX80 video codec. It was tested with the SX80. It
should also control the MX200 G2, MX300 G2, MX700 and MX800. It also provides true
feedback. Not all functions are available on all models. Also, some functions may requir
the installation of option key
s. For more information on the options please contact Cisco.
Note that you do not have the ability to store presets on the far end system. To store a
preset on the near end system, press and hold the desired preset button for 2 seconds.
The Near_End_Camera_Preset_Stored output will pulse, and the preset will be saved.
For presentations, you have the ability to select any near end video source for
transmission. For far end control, you can select any of the far end video sources.
For manual dialing, you have the ability to select from any of the available call
qualities. You also have the ability to designate what type of call to place
(H323/SIP/H320).
For phone book dialing, you have the ability to dial any of the entries that have been
entered into the Cisco local and corporate directories.
The phone book will be downloaded into the Crestron processor all at once and
stored. This will be done upon system initialization. It is recommended that the
phone book is downloaded each night to make sure all updates have been read
into the Crestron processor. It is possible that some of the phone book entries
may be folders. There are outputs on the module that indicate if the selected
entry is a folder. Once you are inside a folder, you can use the
Phone_Book_Up_One_Level input to move back to the previous phone book
level. There is an output called Phone_Book_Names_XSIG. This serial output is
intended to be routed to an Intersystem Communications symbol (Speed Key:
XSIG). There should be 255 serial outputs on the XSIG symbol in your program.
This allows the phone book to be displayed using a Vertical Button List Smart
Graphic object. The other two signals needed are
Phone_Book_Selected_Entry_In to be routed from the Item_Clicked output on
the Vertical Button List object symbol and Phone_Book_Total_Rows_Value to be
routed to the Set_Num_of_Items input on the Vertical Button List symbol. A
folder will be indicated by the addition of “[+] “ in front of the name of the
entry.
This module is NOT System Builder compatible. It is for use in 2-series and higher
CRESTRON HARDWARE REQUIRED:
C2I-*COM*, ST-COM, C2-COM-*
SETUP OF CRESTRON HARDWARE:
RS232
Baud: 115200
Parity: None
Data Bits: 8
Stop Bits: 1
Comments to this Manuals