Cisco AIR-ACC-CLIP-20= Datasheet download pdf (Page 3)

REVIEW DRAFT—CISCO CONFIDENTIAL

Cisco Aironet Converter Clip for Channel Grid Suspended Ceilings (AIR-ACC-CLIP-20)

78-18348-01

Mounting an Antenna

Mounting an antenna on a channel grid suspended ceiling requires two converter clips. The clips attach

to the ceiling channel and must be disassembled before you can attach them. Figure 2 shows how the

converter clips are installed on a channel and how the antenna attaches to the converter clips.

Figure 2 Antenna Mounted on a Ceiling Channel

Follow these steps to mount the antenna on a suspended ceiling channel.

Step 1 Identify the location where you intend to mount the antenna.

Step 2 Raise the ceiling tiles on both sides of the channel. If desired, you can remove the tiles.

Step 3 Use a ruler to measure the distance between the center points of the antenna E-Z clips.

Step 4 Use a pencil to mark the distance you measured in Step 2 channel where you will install the converter

clips. Make sure the marks are above the channel so you can see them when you install the converter

clips.

Step 5 Remove two converter clips from the mounting kit.

Step 6 Disassemble each converter clip by pushing on its OFF tabs using your thumb and forefinger. See

Figure 3.

1 Channel converter clip 2 Antenna mounting E-Z clip

1 2 3 4 5 6 7 8

No comments

Cisco AIR-ACC-CLIP-20= Datasheet Page 3