Cisco 12012 User Manual download pdf (Page 32)

32 Cisco 12012 Gigabit Switch Router Card Cage Assembly Replacement Instructions

FCC Class A Compliance

Step 3 Verify that all source voltage circuit breakers supplying power to your system are on.

Step 4 Turn the power switch on each power supply to ON (|). The input OK LED on each

DC-input power supply (AC OK LED on each AC-input power supply) should go on.

Note Turning the power supply switch to ON (|) also engages a latch securing the power

supply in place.

Step 5 Listen for the blower modules to power up. The green fans OK LED on the front cover of

each blower module should go on.

Step 6 On the console terminal, verify that the console displays the system banner and that the

system and all interfaces initialize successfully.

If the power supplies do not power up, or if the system or any interfaces do not initialize properly,

refer to the Cisco 12012 Gigaswitch Router Installation and Configuration Guide that shipped with

your router for additional information and installation troubleshooting procedures. If you are still

unable to resolve the problem, contact your service representative for assistance.

FCC Class A Compliance

This equipment has been tested and found to comply with the limits for a Class A digital device,

pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection

against harmful interference when the equipment is operated in a commercial environment. This

equipment generates, uses, and can radiate radio-frequency energy and, if not installed and used in

accordance with the instruction manual, may cause harmful interference to radio communications.

Operation of this equipment in a residential area is likely to cause harmful interference, in which

case users will be required to correct the interference at their own expense.

You can determine whether your equipment is causing interference by turning it off. If the

interference stops, it was probably caused by the Cisco equipment or one of its peripheral devices.

If the equipment causes interference to radio or television reception, try to correct the interference

by using one or more of the following measures:

• Turn the television or radio antenna until the interference stops.

• Move the equipment to one side or the other of the television or radio.

• Move the equipment farther away from the television or radio.

• Plug the equipment into an outlet that is on a different circuit from the television or radio. (That

is, make certain the equipment and the television or radio are on circuits controlled by different

circuit breakers or fuses.)

Modifications to this product not authorized by Cisco Systems, Inc. could void the FCC approval

and negate your authority to operate the product.

1 ... 31 32 33 34

No comments

Cisco 12012 User Manual Page 32