Cisco MEM-NPE-G1-FLD256= Datasheet download pdf (Page 5)

1-5

Memory Replacement Instructions for the Network Processing Engine or Network Services Engine and Input/Output Controller

OL-8358-03

Chapter 1 CompactFlash Disk, Flash Disk, and Flash Memory Card Information

Installing and Removing a CompactFlash Disk, Flash Disk, or Flash Memory Card

See the “Reformatting a CompactFlash Disk, Flash Disk, or Flash Memory Card” section on page 1-7

for instructions on how to reformat a memory card.

Note For safety warnings for the memory cards, see the “Safety Guidelines” section on page 3-8.

An I/O controller has two physical PC card slots: slot 0 (lower) and slot 1 (upper). (See Figure 1-1.) The

NPE-G1 and NPE-G2 hve one CompactFlash Disk slot. (See Figure 1-2.)

Note Do not confuse the physical card slot name with the proper device name to use when addressing the card.

Linear memory cards are addressed as the slot0: and slot1: devices. Flash Disk cards are inserted into

the slot0 and slot1 physical slots but are addressed as the disk0: and disk1: devices. The CompactFlash

Disk is inserted into the one slot on the NPE-G1 or NPE-G2 and is addressed as the disk2: device.

To install a Flash Disk or PC card in a PC card slot, complete the following steps.

Figure 1-1 Installing and Removing a PC Card or Flash Disk

H6437

1 2 3 4 5 6 7 8 9 10 ... 19 20

No comments

Cisco MEM-NPE-G1-FLD256= Datasheet Page 5