Cisco 3660 User Manual download pdf (Page 8)

Accessing the NAM CLI

The NM-NAM does not have an external console port. Console access to the NAM is established when

you enter service-module analysis-Module slot/0 session in privileged EXEC mode on the router. The

lack of an external console port on the NM-NAM means that the initial boot configuration can only

be made through the router.

Step 1 Establish a console session with the NAM.

Router# service-module analysis-module slot/0 session

Note If the Connection refused by remote host message is displayed, you must clear the existing

session.

Router# service-module analysis-module

slot

/0 session clear

Step 2 At the login prompt, enter root to log in to the root account.

Step 3 If you have not changed the password from the factory-set default, enter root as the root

password.

Step 4 Perform the required tasks in the NAM CLI. For information on NAM CLI tasks, see the

“Configuring the NAM Management Network Parameters” section on page 9. When you

want to end the NAM console session and return to the Cisco IOS CLI, enter exit.

Note If you are in a subcommand mode, continue to enter the exit command until you see the

NAM login prompt.

Step 5 Hold CTRL-Shift and press 6. Release all keys, then press x to suspend and close the Telnet

session.

Step 6 Enter disconnect to disconnect the line.

Note For 12.3(11)T or later, use the command disconnect <session_id> to disconnect the line.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 17 18

No comments

Cisco 3660 User Manual Page 8