Page
Stage the UC500 Series Platform
1
Page
Note: Throughout the rest of this document, the
terms “UC500” and “CE520” refer to the Cisco Unied
Communications 500 Series platform and the Cisco
Catalyst Express 520 Switch, respectively.
The UC500 can be installed on a desktop or mounted
on a wall or rack. This document describes the desktop
installation (installing the UC500 on a desktop, table, or
shelf). For wall- or rack-mounting instructions, refer to the
documentation for the UC500 platform.
This document assumes that PC-1, the PC that is running
the Cisco Conguration Assistant and that will be used to
perform the initial installation, is connected directly to the
UC500. However, the Cisco Conguration Assistant can be
run on a PC that is connected to the UC500 through a VPN
connection, if desired.
1
Unpack the UC500, place it on a desktop, and power it up.
Download a copy of the Cisco Conguration Assistant
from Cisco.com at http://www.cisco.com/go/
congassist.
Install the Cisco Conguration Assistant on PC-1.
Follow the prompts. When the setup is complete, click
Finish.
Launch the Cisco Conguration Assistant by clicking
the desktop icon.
5
Connect PC-1 to one of the PoE ports on the UC500,
as illustrated. Verify that PC-1 is set to obtain its IP
address using DHCP.
6
From the Cisco Conguration Assistant:
•
Choose Connect to a new community, and enter a
name for the community.
• I
n the IP address eld, enter 192.168.10.1 and click OK.
•
Use the default system administrator username and
password for the UC500.
•
Use the default conguration settings for the rest of
the installation.
The following are precongured:
• Network and device parameters
• Internet connection (DHCP)
• Firewall and Network Address Translation (NAT)
Note: If you are installing a single-site key system
conguration, change the Voice System Type setting from
PBX to Key System Conguration. This setting is in the
Telephony > Voice > Device Parameters tab.
7
Click OK to save the conguration changes to the
UC500. The system indicates when the conguration is
complete.
8
From the Cisco Conguration Assistant, verify that the
UC500 appears in the Topology View window.
Tip! Throughout these installation instructions, you
are instructed to verify that the Topology View window
includes the new device. If the Topology View window
does not include the new device, then choose Application
Menu > Refresh to refresh the Topology View window. For
more information about the Cisco Conguration Assistant,
see the online help.
Page
Congure the UC500 Series Platform
1
8^hXdJc^[^ZY8dbbjc^XVi^dch
*%%HZg^ZhEaVi[dgb
8^hXd
8dc[^\jgVi^dc
6hh^hiVci
E8"&
>ciZgcZi
230633
(32 pages)
(66 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals