Cisco 7507 User Manual download pdf (Page 28)

Format a Flash Memory Card

Install Field Replaceable Units (FRUs)

Flash memory cards shipped as spare parts must be

formatted. Use only Intel Series 2+ Flash memory

cards.

Step 1 Enter format slot0: (or format slot1:) to

format the Flash memorycard, as follows:

Router# format slot0:

Step 2 At the erase all sectors prompt, press

Enter to proceed.

All sectors will be erased, proceed? [confirm]

Step 3 At the volume ID prompt, enter the ID

name:

Enter volume id (up to 30 characters):

MyNewCard

Formatting sector 1

Format device slot0 completed

Router#

Copy Files to Flash Memory

To upgrade to a new Cisco IOS image, copy the

image ﬁle to Flash memory. Upgrade images one at a

time; do not delete all known good images at one

time. You cannot copy an image while the system is

running from Flash memory.

Use the command copy tftp:ﬁlename [bootﬂash |

slot0 | slot1]: ﬁlename for the copy procedure, where

tftp:ﬁlename is the source of the ﬁle and [bootﬂash |

slot0 | slot1]: ﬁlename is the destination in bootﬂash

memory or on either of the Flash memory cards.

An example of the copy tftp:ﬁlename command

follows for a ﬁle in the Flash memory card in PC

Card slot 0:

Router# copy tftp:myfile1 slot0:myfile1

20575008 bytes available on device slot0,

proceed? [confirm]

Address or name of remote host [1.1.1.1]?

Loading new.image from 1.1.1.1 (via

Ethernet1/0):

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!![OK -

7799951/15599616 bytes]

CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC

Router#

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 43 44

No comments

Cisco 7507 User Manual Page 28