Cisco MGBSX1 User Manual

Quick Start GuideCisco Small Business300 Series Managed Switches

10 300 Series Managed SwitchesFeatures of the Cisco Small Business Managed SwitchThis section describes the exterior of the managed switches including

300 Series Managed Switches 11PoE (if present)—(Amber) Located on the right of the port. Lights steady to indicate that power is being supplied to a d

12 300 Series Managed SwitchesReturning the Device to the Factory Default SettingsTo use the Reset button to reboot or reset the managed switch, do th

300 Series Managed Switches 13Where to Go From HereSupportCisco Small Business Support Communitywww.cisco.com/go/smallbizsupportCisco Small Business S

14 300 Series Managed Switches

300 Series Managed Switches 15

Americas HeadquartersCisco Systems, Inc.170 West Tasman DriveSan Jose, CA 95134-1706USAhttp://www.cisco.comTel: 408 526-4000Small Business Support US:

2 300 Series Managed SwitchesWelcomeThank you for choosing the Cisco 300 Series Managed Switch, a Cisco Small Business network communications device.

300 Series Managed Switches 3Circuit Overloading—Adding the device to the power outlet must not overload that circuit.Rack-Mount PlacementTo rack-moun

4 300 Series Managed SwitchesConnecting Network DevicesTo connect the managed switch to the network:STEP 1 Connect the Ethernet cable to the Ethernet

300 Series Managed Switches 5Configuring the Cisco Small Business Managed SwitchBefore You BeginVerify that a computer with Microsoft Internet Explore

6 300 Series Managed Switchesand the computer. You may need to disconnect and reconnect the devices for them to discover their new IP addresses from t

300 Series Managed Switches 7STEP 3 Configure the utility with the following parameters:• 115200 bits per second• 8 data bits• no parity• 1 stop bit•

8 300 Series Managed SwitchesTroubleshoot Your ConnectionIf you cannot access your switch from the web-based smart switch configuration utility, the s

300 Series Managed Switches 9No IP route: If the switch and your computer are in different IP subnets, you need one or more routers to route the packe