Getting to Know the WRP400
Placement Positions
Cisco WRP400 User Guide 15
1
STEP 3 Drill two holes, 60 mm (2.36 inches) apart. Insert a screw into each hole and leave
3 mm (0.12 inches) of the head exposed.
To create a template to position the screws, you can print this page at 100 percent.
Then cut along the dotted line. Affix this template to the wall where you want to
drill the holes.
Figure 3 Wall Mount Template
NOTE Cisco is not responsible for damages incurred by insecure wall-mounting
hardware.
STEP 4 Position the WRP400 so that two of the wall-mount slots are over the two screws.
Slide the WRP400 down until the screws fit snugly into the wall-mount slots.
Comments to this Manuals