Cisco TES301 User's Guide download pdf (Page 57)

VoIP Settings

4038767 Rev A 37

b Click the Move Right arrow to move the selected item to the Enabled Codec

list.

c Use the Up/Down buttons to prioritize the Enabled Codecs.

d Select the top Codec in the Enabled list. The Codec Properties fields become

active.

e Complete the Codec Properties fields associated with the Codec selected:

– Payload Type—This value is pre-populated with a default setting. The

field will not be configurable if the default value is a required setting for

the codec selected.

– Name—Provide a name to identify the codec type.

– Frame Size in ms—Select a setting to configure interval between sending

RTP packets out to the RTP stream.

– Bit Rate—Select the data transmission rate from the list of available

options.

f DTMF Relay Method—Select one of the following methods by which DTMF

digits will be passed during a voice call:

– In Band—Select In Band mode to use the voice band when a key is

pressed during a voice call.

– Out of Band—Select Out of Band mode to use an independent band

when a key is pressed during a voice call. If you select this option, the

RFC2833 Payload Type field will appear for your to enter a value to

configure the RFC 2833 payload decimal.

– SIP Info—Select SIP Info if you want a key press to be sent remotely

through SIP packets during a voice call.

6 Click Save Changes to save the information or Cancel to return to the

dashboard.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 97 98

No comments

Cisco TES301 User's Guide Page 57