Cisco 2500 SERIES User Manual download pdf (Page 12)

4-12 Cisco 2500 Series Access Server User Guide

Configuring the Access Server

Step 7 In most cases you will use IP routing. If you are using IP routing, you must also

select an interior routing protocol. You can specify only one of two interior routing

protocols to operate on your system using setup: Interior Gateway Routing

Protocol (IGRP) or Routing Information Protocol (RIP).

Enter yes (the default) or press Return to conﬁgure IP, and then select an interior

routing protocol for IP:

Configure IP? [yes]:

Configure IGRP routing? [yes]:

Your IGRP autonomous system number [1]: 15

Step 8 In this example, routing will be enabled on AppleTalk and IPX; IP has already

been selected:

Configure AppleTalk? [no]: yes

Multizone networks? [no]: yes

Configure LAT? [yes]: no

Configure IPX? [no]: yes

Conﬁguring the Asynchronous Interface

The access server is equipped with up to 16 asynchronous interfaces, which are referred to

as lines in the setup dialog. The asynchronous lines must be conﬁgured to permit

asynchronous devices to be connected to the access server. (See the sections

“Asynchronous Protocols,” and “Modems” in the appendix “Internetworking Primer.”)

The asynchronous ports on the access server are conﬁgured to allow connection by TTY

devices, Remote nodes, and Remote LANs.

A variety of devices can connect to the access server using the asynchronous lines.

Terminals and remote nodes (such as PCs, Macintosh computers, workstations, and host

systems) connect to the access server and make use of its services. The access server

provides services allowing access to other asynchronous devices, such as printers, modems,

or terminals.

The following steps conﬁgure the lines on the access server to permit use of the

asynchronous lines by the access server or remote devices:

Step 1 Enter yes or press Return to conﬁgure asynchronous lines:

Configure Async lines? [yes]:

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18

No comments

Cisco 2500 SERIES User Manual Page 12