Cisco AIR-ANT2544V4M-R Specifications download pdf (Page 12)

Performing a Pre-Installation Configuration

The following procedures ensure that your access point installation and initial operation go as

expected. A pre-installation configuration is also known as priming the access point. This procedure

is optional.

Note Performing a pre-installation configuration is an optional procedure. If your network

controller is properly configured, you can install your access point in its final location and

connect it to the network from there. See the “Deploying the Access Point on the Wireless

Network” section on page 15 for details.

Pre-Installation Configuration Setup

The pre-installation configuration setup is shown in Figure 4.

Figure 4 Pre-Installation Configuration Setup

To perform pre-installation configuration, perform the following steps:

Controller

Layer 3

devices

Cisco Aironet

access points

272488

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 39 40

No comments

Cisco AIR-ANT2544V4M-R Specifications Page 12