Cisco AIR-ANTM5560P-R= Datasheet Page 11

  • Download
  • Add to my manuals
  • Print
  • Page
    / 18
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 10
11
Cisco Multiband Wall-Mount Antenna (AIR-ANTM5560P-R)
OL-6847-01
Installation Instructions
Figure 6 Mounting the Antenna on a Wall
To mount the antenna on a wall, follow these steps:
Step 1 Choose a location for mounting.
Step 2 If an extension coaxial cable is used, connect it to the access point and extend the coaxial cable to the
location for mounting the antenna.
Step 3 Attach the antenna to the molded antenna mount using the four provided 8-32 nylon lock nuts.
Step 4 Attach the antenna mount to the articulating arm (all mounting hardware is provided):
a. Place a 1/4-in. lock washer, then a 1/4-in. flat washer on a 1/4-20 x 1-1/4-in. machine screw.
b. Insert the screw and washers, first through the molded antenna mount, then the articulating arm.
c. Secure the articulating arm to the molded antenna mount using a 1/4-20 hex nut.
Step 5 Find the molded wall mount and position it on the mounting surface. Use a pencil to mark the location
of the mounting holes. There are four holes for wall-mounting, one in each corner.
Step 6 Using a 3/16-in. (4.7 mm) drill bit, drill holes for the screws at the locations you marked in Step 5.
Step 7 Route the cable either up or down from the wall or corner.
Step 8 Install a wall anchor in each hole.
Step 9 Line up the mounting holes on the molded wall mount with the pilot holes and start one of the provided
8-18 x 3/4-in. self-tapping Phillips screws in each hole.
Step 10 Tighten the screws with a Philips screwdriver.
Step 11 Attach the articulating arm to the molded wall mount (all hardware is provided):
a. Place a 1/4-in. lock washer, then a 1/4-in. flat washer on a 1/4-20 x 1-1/4-in. machine screw.
b. Insert the screw and washers, first through the molded wall mount, then the articulating arm.
c. Secure the articulating arm to the molded wall mount using a 1/4-20 hex nut.
1 Wall anchors 2 Molded wall mount
3 8-18 x 3/4-in. self-tapping Phillips screws 4 Articulating arm
5 Molded antenna mount
2
5
4
1
3
3
135159
Page view 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18

Comments to this Manuals

No comments