Cisco 2504 Specifications download pdf (Page 115)

4-115

Cisco Wireless LAN Controller Configuration Guide

OL-21524-02

Chapter 4 Configuring Controller Settings

Configuring and Viewing Location Settings

Note See the Cisco Wireless Control System Configuration Guide or the Cisco Location Appliance

Configuration Guide for instructions on enabling location presence on a location appliance.

Modifying the NMSP Notification Interval for Clients, RFID Tags, and Rogues

The Network Mobility Services Protocol (NMSP) manages communication between the location

appliance and the controller for incoming and outgoing traffic. If your application requires more frequent

location updates, you can modify the NMSP notification interval (to a value between 1 and 180 seconds)

for clients, active RFID tags, and rogue access points and clients.

Note The TCP port (16113) that the controller and location appliance communicate over must be open (not

blocked) on any firewall that exists between the controller and the location appliance for NMSP to

function.

To modify the NMSP notification interval value on the controller using the controller CLI, follow these

steps:

Step 1 Set the NMSP notification interval value for clients, RFID tags, and rogue clients and access points by

entering these commands, where interval is a value between 1 and 180 seconds:

• config nmsp notification interval rssi clients interval

• config nmsp notification interval rssi rfid interval

• config nmsp notification interval rssi rogues interval

Step 2 See the NMSP notification intervals by entering this command:

show nmsp notification interval

Information similar to the following appears:

NMSP Notification Interval Summary

RSSI Interval:

Client.......................................... 2 sec

RFID............................................ 0 sec

Rogue AP........................................ 2 sec

Rogue Client.................................... 2 sec

Viewing NMSP Settings

To view NMSP information, use these CLI commands:

• See the status of active NMSP connections by entering this command:

show nmsp status

Information similar to the following appears:

1 2 ... 110 111 112 113 114 115 116 117 118 119 120 121 122

No comments

Cisco 2504 Specifications Page 115