Cisco 2504 Specifications download pdf (Page 17)

4-17

Cisco Wireless LAN Controller Configuration Guide

OL-21524-02

Chapter 4 Configuring Controller Settings

Installing and Configuring Licenses

License Priority: Low

The License State text box shows the licenses that are in use, and the License Priority text box shows the

current priority of each license.

Step 2 Activate an ap-count evaluation license as follows:

a. To raise the priority of the base-ap-count evaluation license, enter this command:

license modify priority license_name high

Note You can set the priority only for ap-count evaluation licenses. AP-count permanent licenses

always have a medium priority, which cannot be configured.

b. To reboot the controller in order for the priority change to take effect, enter this command:

reset system

c. To verify that the ap-count evaluation license now has a high priority and is in use, enter this

command:

show license all

You can use the evaluation license until it expires.

Step 3 If you decide to stop using the ap-count evaluation license and want to revert to using an ap-count

permanent license, follow these steps:

a. To lower the priority of the ap-count evaluation license, enter this command:

license modify priority license_name low

b. To reboot the controller in order for the priority change to take effect, enter this command:

reset system

c. To verify that the ap-count evaluation license now has a low priority and is not in use, enter this

command:

show license all

Instead, the ap-count permanent license should be in use.

Rehosting a License

Revoking a license from one controller and installing it on another is called rehosting. You might want

to rehost a license in order to change the purpose of a controller. For example, if you want to move your

OfficeExtend or indoor mesh access points to a different controller, you could transfer the base license

from one controller to another.

In order to rehost a license, you must generate credential information from the controller and use it to

obtain a permission ticket to revoke the license from the Cisco licensing site. Next, you must obtain a

rehost ticket and use it to obtain a license installation file for the controller on which you want to install

the license.

Evaluation licenses and the permanent base image license cannot be rehosted.

Note A revoked license cannot be reinstalled on the same controller.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 121 122

No comments

Cisco 2504 Specifications Page 17