Cisco BayTech DS Series Owner's Manual download pdf (Page 18)

DS-RPC Manual

Default setting is Enabled.

If the Enable/Disable Status Menu feature is disabled, only the DS> prompt appears, else the following

status menu appears.

Change Unit ID

From the configuration menu select “Change Unit ID”. The DS will respond:

The default ID is a ‘Blank’.

Change Alarm Threshold

The Current Alarm Threshold allows the user to set the level of current required to sound the internal

alarm. This setting is only available on units with current monitoring circuitry.

From the configuration menu, select “Change Alarm Threshold.” The DS responds:

Type ‘N’ to keep current value and the DS responds with next outlet group or type ‘Y’ to change the

value and type the new value, followed by <cr>.

Whether you change the current value or not the DS responds with the configuration menu.

Default setting is approximately 80% of unit’s maximum current.

Current Unit ID:

Modify (Y/N)? y

Enter New Unit ID: DS4D-RPC

Unit ID: DS4D-RPC

Buzzer alarm value : 16.0 Amps

Modify (Y/N)? y

Enter: 16.0

1 2 ... 13 14 15 16 17 18 19 20 21 22

No comments

Cisco BayTech DS Series Owner's Manual Page 18