Cisco WS-X4148-FX-MT Datasheet download pdf (Page 10)

Chapter 1 Module Overview and Specifications

Supervisor Engines

1-10

Catalyst 4500 Series Module Installation Guide

78-13267-06

Ethernet Management Port

The WS-X4012 supervisor engine has a 10BASE-T Ethernet management port.

The WS-X4516-10GE and WS-X4013+10GE supervisor engine modules have a

10/100/1000BASE-T Ethernet management port.The other supervisor engine

modules have a 10/100BASE-T Ethernet management port. Supervisor engines

use an RJ-45 connector on the front panel with a link status LED. For the location

of the port, see Figure 1-1 (WS-X4012), Figure 1-2 (WS-X4013), Figure 1-3

(WS-X4013+), Figure 1-4 (WS-X4013+TS), Figure 1-5 (WS-X4013+10GE),

Figure 1-6 (WS-X4014), Figure 1-7 (WS-X4515), Figure 1-8 (WS-X4516), or

Figure 1-9 (WS-X4516-10GE).

TCP/IP-based management services available through inband access also are

provided through this port (Telnet and SNMP). This management port also

supports image download.

Note The 10BASE-T and 10/100BASE-T Ethernet management ports are for network

management only. These ports do not support network switching.

Console Port

The console port allows you to perform the following functions:

• Configure the switch from the CLI

• Monitor network statistics and errors

• Configure SNMP agent parameters

• Download software updates to the switch or distribute software images

residing in Flash memory to attached devices

The Catalyst 4003 console port is a DCE DB-25 receptacle, which supports a

DCE EIA/TIA-232 interface. The console port is an RJ-45 receptacle on the

Catalyst 4006, 4503, 4506, and 4507.

Note EIA/TIA-232 was known as recommended standard RS-232 before its acceptance

as a standard by the Electronic Industries Association (EIA) and

Telecommunications Industry Association (TIA).

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 45 46

No comments

Cisco WS-X4148-FX-MT Datasheet Page 10