Cisco 7507 User Manual download pdf (Page 34)

Copy the Conﬁguration File for an RSP

Install Field Replaceable Units (FRUs)

Refer to the appropriate Cisco IOS software documentation for the conﬁguration options available, and for

speciﬁc conﬁguration instructions, as needed.

Before you copy (save) the running conﬁguration to a TFTP ﬁle server, ensure the following:

• You have a connection to the router either with a console terminal connected to the RSP console port or

remotely through a Telnet session.

• The router is connected to a network supporting a ﬁle server (remote host).

• The remote host supports the TFTP application.

• You have the interface processor address or name of the remote host available.

Step 1 Enter the enable command at the EXEC prompt (>), and then enter a privileged-level password, as

follows:

Router> enable

Password:

Router#

Step 2 Enter the ping command followed by the name or IP address of the remote server, and then press

Return to check the connection between the router and the remote host.

Step 3 Enter the show running-conﬁg command to display the currently running conﬁguration on the

terminal and ensure that the conﬁguration information is complete and correct. If it is not, use the

conﬁgure command to add or modify the existing conﬁguration.

Step 4 Create a ﬁle on the TFTP server.

Note Before you can save a ﬁle to a TFTP server, a ﬁle must ﬁrst exist on the TFTP server. Create this ﬁle.

Ensure that the ﬁlename matches the ﬁlename you will copy from the router. Also, ensure that the server

permissions are set so the router can copy to this ﬁle.

Step 5 Enter the copy startup-conﬁg tftp command. The EXEC command interpreter prompts you for the

name or interface processor address of the remote host that is to receive the conﬁguration ﬁle. (The

prompt might include the name or address of a default ﬁle server.)

Router# copy startup-config tftp

Remote host []?

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 43 44

No comments

Cisco 7507 User Manual Page 34