Cisco SPA3102 User's Guide download pdf (Page 33)

Voice Gateway with Router

Chapter 6: Using the Web-based Utility

The Router Tab

The Router - WAN Setup Screen

This screen lets you configure the Internet connection, MAC clone, remote management, QoS, VLAN, and

optional settings. Information about your Internet connection type should be provided by your Internet Service

Provider (ISP). If you do not have this information, contact your service provider.

Internet Connection Settings

Connection Type. Select the connection type you use: DHCP; Static IP; PPPOE; PPPoE, DHCP; or DHCP,

PPPoE. If you select PPPoE, DHCP or DHCP, PPPoE, then the Voice Gateway will try the first Internet connection

type. If that fails, then the Voice Gateway will try the second Internet connection type.

Static IP Settings

If you selected Static IP, complete the Static IP Settings section.

Static IP. Enter the static or fixed IP address of the Voice Gateway (this should be provided by your ISP).

NetMask. Enter the net or subnet mask of the Voice Gateway (this should be provided by your ISP).

Gateway. Enter the IP address of the gateway (this should be provided by your ISP).

PPPoE Settings

If you selected PPPOE, complete the PPPoE Settings section.

PPPoE Login Name. Enter the name provided by your ISP.

PPPoE Login Password. Enter the password provided by your ISP.

Figure 6-4: Static IP Settings

Figure 6-3: Router - WAN Setup Screen

Figure 6-5: PPPoE Settings

NOTE: For DSL users, if you

need to enable PPPoE support,

remember to remove any PPPoE

applications that are installed

on your PCs.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 99 100

No comments

Cisco SPA3102 User's Guide Page 33