24
Release Notes for Cisco uBR924 Cable Access Router for Cisco IOS Release 12.1(5)T
OL-0385-04 Rev. B0 (2/2001)
Important Notes
• xgcpMsgStatTable—Table that contains SGCP statistics information since reset
• xgcpMsgStatEntry—Row in the “xgcpMsgStatTable” that contains information about SGCP
message statistics per IP address of the Media Gateway Controller (MGC)
• xgcpIPAddress—IP address of the MGC
• xgcpSuccessMessages—Number of successful messages that communicate with the MGC on that
IP address
• xgcpFailMessages—Number of failed messages that communicate with the MGC on that IP
address
• xgcpUpDownNotification—Notification sent when the protocol status changes between up and
down
Note For complete details on the SGCP and MGCP MIB, see the XGCP-MIB.my file on the
CCO MIB web site.
Cable-Specific MIBs
Table 4 shows the cable-specific MIBs that are supported on the Cisco uBR924 Cable Access Router.
This table also provides a brief description of each MIB’s contents and the Cisco IOS software release
in which the MIB was initially functional—earlier releases might have had unsupported prototype
versions of the MIB; later releases might have added new attributes and functionality.
Note The names given in Table 4 are the filenames for the MIBs as they exist on Cisco’s FTP
site (ftp://ftp.cisco.com/pub/mibs/). Most MIBs are available in both SNMPv1 and
SNMPv2 versions; the SNMPv1 versions have V1SMI as part of their filenames. Also see
the Cisco MIBs home page at
http://www.cisco.com/public/sw-center/netmgmt/cmtk/mibs.shtml.
Table 4 Supported MIBs for the Cisco uBR924 Cable Access Router
MIB Filename Description Release
SNMPv2-SMI.my
SNMPv2-SMI-V1SMI.my
This module specifies the Structure of Management
Information (SMI) for SNMPv2, as defined in RFC 1902.
12.0(4)XI
SNMPv2-TC.my
SNMPv2-TC-V1SMI.my
This module defines the textual conventions as specified in
pages 4 and 10-11 of RFC 854.
12.0(4)XI
CISCO-SMI.my
CISCO-SMI-V1SMI.my
This module specifies the SMI for Cisco’s enterprise MIBs. 12.0(4)XI
CISCO-TC.my
CISCO-TC-V1SMI.my
This module defines the textual conventions used in Cisco’s
enterprise MIBs.
12.0(4)XI
IF-MIB.my
IF-MIB-V1SMI.my
This module describes generic objects for the Layer 3 network
interface sublayers. This MIB is an updated version of
MIB-II’s if table, and incorporates the extensions defined in
RFC 2233.
12.0(4)XI
RFC 2233
support:
12.1(2)T
Comments to this Manuals