Cisco 600W User Manual download pdf (Page 14)

Management Options (FastHub 400M Models)

FastHub 400 10/100 Series Installation and Configuration Guide

1-14

Default Conﬁguration Settings

The hub is designed to operate with little or no user intervention. After you assign the IP

information, the hub uses its default settings (Table 1-9) and begins forwarding packets as

soon as it is powered up and connected to compatible devices.

For procedures on how to reset all hub console port settings to the factory defaults, see the

“Resetting the Hub to the Factory Defaults” section on page 4-15.

Table 1-9 Default Settings and FastHub 400 series Hub Manager Pages

Feature Default Setting Hub Manager Page

Management

IP information 0.0.0.0 IP Management Page

Stack management — Group Management Page

Cisco Discovery Protocol (CDP) Enabled CDP Management Page

Performance Tuning

Speed of ports Autonegotiate Port Management Page

Switched Uplink Module

Management Page

Duplex mode of module ports Autonegotiate Switched Uplink Module

Management Page

Security

Hub password None Home Page

Community string public/private SNMP Management Page

Trap manager None SNMP Management Page

Write manager None SNMP Management Page

Diagnostics

Usage reports — Detailed Port Statistics Page

Detailed Switched Uplink

Module Statistics Page

Detailed Group Statistics Page

Remote monitoring Enabled —

Upgrades

Firmware — System Conﬁguration Page

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20 21 22

No comments

Cisco 600W User Manual Page 14