Cisco PWR-1400-AC= Datasheet download pdf (Page 9)

Guide to Supported Hardware for Cisco 7600 Series Routers with Cisco IOS Release 12.2SR

OL-10362-04

Supported Hardware

RSP720-3C-10GE

Product ID

(append “=” for spares)

Power

Required Product Description

Minimum

Software Version

RSP720-3C-10GE

7.33 A@42 V Route Switch Processor 720 with uplink ports:

• Two 10 Gigabit Ethernet (10-GE) uplink ports support

10-Gbps X2 modules

• Three Gigabit Ethernet (1-GE) uplink ports: two ports support

1-Gbps small form-factor pluggable (SFP) module; one port

supports 10/100/1000-Mbps RJ-45 connector

• Integrated 720-Gbps switch fabric

• PFC3C and MSFC4 with 512-MB bootflash, 4-MB

NVRAM, 4-MB ROMmon, and several DRAM options:

–

Route processor (RP): 1- to 2-GB DRAM (default 1

GB)

–

Switch processor (SP): 1- to 2-GB DRAM (default 1

GB)

• One CompactFlash Type II slot (on front panel) and one

2-GB internal CompactFlash (1 GB each for RP and SP)

• Requires larger power supplies and a high-speed fan tray

• QoS port architecture, 10-GE ports (Rx/Tx): 8q8t/1p7q8t

(CoS)

• QoS port architecture, 1-GE ports (Rx/Tx): 2q8t/1p3q8t

12.2(33)SRC

Note

•

There are no memory-only upgrade options for the RSP720-3C-10GE.

• The RSP720-3C-10GE does not support the following chassis and modules:

–

Unsupported chassis: Cisco 7603, 7606, and 7613 chassis

–

Unsupported modules: Services modules, Optical Service Modules (OSMs), FlexWAN module.

• The RSP720-3C-10GE supports the following 10-Gigabit Ethernet optics: X2-10GB-LR, X2-10GB-ER, X2-10GB-SR,

X2-10GB-CX4, and X2-10GB-LX4.

• The RSP720-3C-10GE supports the following Gigabit Ethernet optics: GLC-SX-MM, GLC-LH-SM, GLC-ZX-SM,

GLC-T, SFP-GE-S, SFP-GE-L, SFP-GE-T, and GLC-BX-D.

In Cisco IOS Release 12.2SRC, the RSP720-10GE does not support the following features, which are supported on the

RSP720:

• High-availability features such as NonStop Forwarding with Stateful Switchover (NSF/SSO) and In-Service Software

Upgrade (ISSU) are not supported. Only Route Processor Redundancy (RPR) mode is supported.

• The uplinks on the standby RSP720-10GE are not active. This restriction exists because the uplink ports must perform

lookups on the active RSP, which is not possible in RPR mode.

• Broadband aggregation features are not supported.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 67 68

Comments to this Manuals

No comments

Cisco PWR-1400-AC= Datasheet Page 9

Comments to this Manuals

Related products and manuals for Power supply units Cisco PWR-1400-AC=