Cisco 15454E-CTP-MIC48V= Datasheet Page 4

  • Download
  • Add to my manuals
  • Print
  • Page
    / 10
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 3
4
Installing ONS 15454 SDH MIC-C/T/P Cards
78-14311-01
Installation Procedures
(modem port for future use)
Connectors: 8-pin RJ-45
MIC-C/T/P System Management LAN Port Interface:
Signal: 802.3 10 BaseT
Connectors: 8-pin RJ-45
Environmental
Operating Temperature: -5 to +45 degrees Celsius
Operating Humidity: 5 - 95%, non-condensing
Power Consumption: 0.4 W, (provided by +5V from TCC-I), 1.37 BTU/Hr.
Dimensions
Height: 182 mm, (7.165 in.)
Width: 32 mm, (1.25 in.)
Depth: 92 mm, (3.62 in.)
Depth with backplane connector: 98 mm, (3.87 in.)
Weight not including clam shell: 0.2 kg (0.5 lbs.)
Compliance
ONS 15454 SDH cards, when installed in a system, comply with these standards:
Safety: IEC 60950, EN 60950, UL 60950, CSA C22.2 No. 60950, TS 001, AS/NZS 3260
Installation Procedures
Use this section if you are installing or removing the MIC-C/T/P card for the first time. After you
become familiar with ONS 15454 SDH card installation and boot up, use this section as a reference.
Caution Always use the supplied electrostatic discharge (ESD) wristband when working with an ONS 15454
SDH. Plug the wristband cable into the ESD jack located on the lower right outside edge of the shelf
assembly and ensure the shelf assembly is properly grounded.
Caution Hazardous voltage or energy may be present on the backplane when the system is operating. Use caution
when servicing.
Step 1 Carefully insert the card into the rails of slot 24 (Figure 3 on page 5).
Step 2 Move the upper ejector down and the lower ejector up to enable the card being inserted into the
backplane connectors.
Step 3 Gently push the card into the connector on the back plane.
Step 4 Tighten the front mounting screws with a Phillips or slot screwdriver.
Page view 3
1 2 3 4 5 6 7 8 9 10

Comments to this Manuals

No comments