Cisco 15454E-CTP-MIC48V= Datasheet download pdf (Page 5)

Installing ONS 15454 SDH MIC-C/T/P Cards

78-14311-01

Installation Procedures

MIC-C/T/P cards have electrical plugs that plug into electrical connectors on the shelf assembly

backplane. When the ejectors are fully closed and the mounting screws are tightened, the card plugs into

the shelf assembly backplane. Figure 3 on page 5 shows general card installation. Connecting the power

cable is described in Chapter 1 “Installation” of the Cisco ONS 15454 SDH Installation and Operations

Guide.

Figure 3 Installing an FMEC card in an ONS 15454 SDH

Card Turn Up

Follow the steps in this section to verify card turn up. If one or more of the Cisco Transport Controller

(CTC) software screen conditions according to “Verify Successful Turn Up of the MIC-C/T/P Card”

section on page 5 are not met, re-install the card. Replace the unit if the faulty state persists.

Verify Successful Turn Up of the MIC-C/T/P Card

Step 1 Verify that power is applied to the shelf assembly.

Step 2 Verify that the MIC-C/T/P card has been installed in slot 24.

Step 3 Verify that the card appears in slot 24 on the CTC software screen.

Step 4 Verify that the card is white on the CTC software screen.

61338

FAN FAIL

CRIT

MAJ

MIN

ounting screws

Guide rail

1 2 3 4 5 6 7 8 9 10

No comments

Cisco 15454E-CTP-MIC48V= Datasheet Page 5