Cisco Aironet 1100 Series Installation Guide Page 26
- Page / 122
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
2-2
Cisco Aironet 1100 Series Access Point Hardware Installation Guide
OL-4309-02
Chapter 2 Installing the Access Point
Safety Information
Safety Information
Follow the guidelines in this section to ensure proper operation and safe use of the access point.
FCC Safety Compliance Statement
The FCC with its action in ET Docket 96-8 has adopted a safety standard for human exposure to radio
frequency (RF) electromagnetic energy emitted by FCC certified equipment. When used with approved
Cisco Aironet antennas, Cisco Aironet products meet the uncontrolled environmental limits found in
OET-65 and ANSI C95.1, 1991. Proper installation of this radio according to the instructions found in
this manual will result in user exposure that is substantially below the FCC recommended limits.
General Safety Guidelines
• Do not touch or move antenna(s) while the unit is transmitting or receiving.
• Do not hold any component containing a radio so that the antenna is very close to or touching any
exposed parts of the body, especially the face or eyes, while transmitting.
• The use of wireless devices in hazardous locations is limited to the constraints posed by the local
codes, the national codes, and the safety directors of such environments.
Warnings
Translated versions of the following safety warnings are provided in Appendix A, “Translated Safety
Warnings.”
Warning
In order to comply with FCC radio frequency (RF) exposure limits, dipole antennas should be located
at a minimum of 7.9 inches (20 cm) or more from the body of all persons.
Warning
Do not operate your wireless network device near unshielded blasting caps or in an explosive
environment unless the device has been modified to be especially qualified for such use.
Warning
Do not work on the system or connect or disconnect cables during periods of lightning activity.
Warning
Read the installation instructions before you connect the system to its power source.
Warning
This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure that
a fuse or circuit breaker no larger than 120 VAC, 15A U.S. (240 VAC, 10A international) is used on the
phase conductors (all current-carrying conductors).
- Hardware Installation Guide 1
- CONTENTS 3
- Contents 4
- 6 Mounting Instructions 6-1 5
- 7 2.4-GHz Radio Upgrade 7-1 5
- 8 Troubleshooting 8-1 6
- Audience 9
- Organization 9
- Conventions 10
- Related Publications 12
- Obtaining Documentation 12
- Documentation CD-ROM 13
- Ordering Documentation 13
- Documentation Feedback 13
- Cisco TAC Website 14
- Opening a TAC Case 14
- TAC Case Priority Definitions 14
- Overview 17
- Hardware Features 18
- Power Sources 19
- UL 2043 Certification 20
- Anti-Theft Features 20
- Root Unit on a Wired LAN 21
- Access Point 22
- (Repeater) 22
- Wired LAN 22
- (Root Unit) 22
- Chapter 1 Overview 24
- Installing the Access Point 25
- Safety Information 26
- Warnings 26
- Unpacking the Access Point 27
- Basic Installation Guidelines 27
- Installation Summary 28
- Option 1 Option 2 Option 3 29
- Option 4 29
- Powering Up the Access Point 31
- Before You Start 34
- Assigning Basic Settings 36
- Figure 3-2 Express Setup Page 37
- Protecting Your Wireless LAN 40
- Using the IP Setup Utility 40
- • Using Online Help, page 4-5 45
- Step 1 Start the browser 46
- Using Action Buttons 47
- Configuration Action Buttons 48
- Using Online Help 49
- IOS Command Modes 52
- Getting Help 53
- Abbreviating Commands 53
- Understanding CLI Messages 54
- Using Command History 54
- Recalling Commands 55
- Using Editing Features 56
- Accessing the CLI 59
- Mounting Instructions 61
- 1 4 43 3 42 63
- Using the Desktop Holster 69
- Figure 6-9 Desktop Holster 70
- Using the Cable Lock Feature 71
- 2.4-GHz Radio Upgrade 73
- Upgrade Overview 74
- Unpacking the Radio 74
- Removing the Back Cover 75
- Removing a 2.4-GHz Radio 76
- Installing a 2.4-GHz Radio 77
- Replacing the Back Cover 80
- Finding the Software Version 81
- Troubleshooting 83
- Checking the Top Panel LEDs 84
- Checking Basic Settings 86
- Using the MODE Button 87
- Using the MODE button 88
- Web Browser Interface 89
- Translated Safety Warnings 91
- Lightning Activity Warning 94
- Installation Warning 95
- Circuit Breaker (15A) Warning 95
- Information 97
- Tested To Comply 98
- With FCC Standards 98
- FOR HOME OR OFFICE USE 98
- Liechtenstein 99
- • Safety: EN 60950 100
- Bridges in Japan 101
- All Access Points 102
- OL-4309-02 103
- Access Point Specifications 105
- Radio 2.4-GHz Radio 106
- Channels and Antenna Settings 109
- Channels 110
- IEEE 802.11g (2.4-GHz Band) 111
- Maximum Power Levels 112
- GLOSSARY 113
- Glossary 114
Related products and manuals for Routers Cisco Aironet 1100 Series
Routers Cisco AG241 User's Guide
(80 pages)
(80 pages)
Routers Cisco E1550 User's Guide
(55 pages)
(55 pages)
Routers Cisco PLE300 User Manual
(2 pages)
(2 pages)
Routers Cisco Linksys WAG160N User's Guide
(41 pages)
(41 pages)
Routers Cisco uBR924 Specifications
(52 pages)
(52 pages)
Routers Cisco WPC54GX User's Guide
(51 pages)
(51 pages)
Routers Cisco 4G-LTE-ANTM-O-3 Installation Guide
(444 pages)
(444 pages)
Routers Cisco IP/TV 3400 Series User's Guide
(24 pages)
(24 pages)
Routers Cisco WRT610N User's Guide
(67 pages)
(67 pages)
Routers Cisco WRP400 User's Guide
(49 pages)
(49 pages)
Routers Cisco WPC300N User's Guide
(65 pages)
(65 pages)
Routers Cisco WPC54GX User's Guide
(54 pages)
(54 pages)
Routers Cisco WMP300N User's Guide
(65 pages)
(65 pages)
Routers Cisco WMP54GR User's Guide
(59 pages)
(59 pages)
Routers Cisco RV042G User's Guide
(103 pages)
(103 pages)
Routers Cisco WMP54GS User's Guide
(67 pages)
(67 pages)
Routers Cisco E800 User's Guide
(46 pages)
(46 pages)
© 2020, manymanuals.com. All rights reserved. | 0.773 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals