Cisco Aironet 1100 Series Installation Guide Page 76

  • Download
  • Add to my manuals
  • Print
  • Page
    / 122
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 75
7-4
Cisco Aironet 1100 Series Access Point Hardware Installation Guide
OL-4309-02
Chapter 7 2.4-GHz Radio Upgrade
Removing a 2.4-GHz Radio
Removing a 2.4-GHz Radio
To remove a 2.4-GHz radio card from your access point, follow these steps:
Caution The internal access point components and the 2.4-GHz radio can be damaged by ESD from improper
handling.
Step 1 Gently lift the top of the antenna card until it clears the plus shaped (+) support post (see Figure 7-2).
Figure 7-2 Radio Card and Antenna Card
Step 2
Gently pull the antenna card to remove it from the notch in the support bracket. Do not disconnect the
antenna wire connectors.
Step 3 Push the card-retaining clips (on each side of card) away from the radio card (see Figure 7-2). When
released, the radio card springs up. Do not disconnect the antenna wires.
Note If the radio card does not spring up, slightly loosen the support bracket screws.
Step 4 Remove the 2.4-GHz radio card from the mini-PCI connector:
a. Grasp the radio card only on the edges, being careful not to touch components on the board or the
gold connector pins.
b. Remove the 2.4-GHz card from the mini-PCI connector.
1 Support post 4 Radio Card
2 Antenna card 5 Card-retaining clips
3 Support bracket 6 Mini-PCI connector
95755
1
2
3
4
5
6
5
Page view 75
1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 121 122

Comments to this Manuals

No comments