Cisco Linksys WAG160N User's Guide download pdf (Page 10)

Chapter 4

Advanced Configuration

Wireless ADSL2+ Modem Router

Chapter 4:

Advanced Configuration

After you have finished running the Setup Wizard on

the Setup CD-ROM, the Modem Router is ready for use.

You may wish, however, to change the Modem Router’s

advanced settings. To do this, use the provided web-

based utility. You can access the utility via a web browser

on a computer connected to the Modem Router.

NOTE: For New Zealand, follow these

instructions after accessing the web-based utility

in the Setup > Basic Setup screen:

Select 1. RFC 2364 PPPoA from the

Encapsulation drop-down menu.

For the Virtual Circuit ID, enter 2. 0 for the VPI

and 100 for the VCI.

Select 3. VC for Multiplexing.

Select 4. Multimode from the DSL Modulation

drop-down menu.

Enter your User Name and Password details 5.

from your ISP.

Click 6. Save Settings.

How to Access the Web-Based Utility

To access the web-based utility, launch the web browser

on your computer, and enter the Modem Router’s default

IP address, 192.168.1.1, in the Address field. Then, press

Enter.

A login screen appears. Use the default user name and

password, admin, unless you changed them when you

ran the Setup Wizard. (You can set a new user name and

password from the Administration tab’s Management

screen.) Click OK to continue.

Modem Router Login

If you are unable to log in, press the Reset button on the

back panel for at least 5 seconds, then wait for the device

to reset and try again.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 95 96

No comments

Cisco Linksys WAG160N User's Guide Page 10