Cisco WRP400 User's Guide download pdf (Page 5)

Chapter 1

Product Overview

Wireless-G Broadband Router with 2 Phone Ports

Chapter 1:

Product Overview

Thank you for choosing the Linksys Wireless-G Broadband

Router with 2 Phone Ports. The Router lets you access

the Internet via a wireless connection or through one of

its four switched ports. You can also use the Router to

share resources such as computers, printers and files. The

built-in phone adapter enables Voice-over-IP (VoIP) calls

even while you are using the Internet.

Front Panel

USB The USB port is reserved for future use.

Wi-Fi Protected Setup (White/Orange) If you

have client devices, such as wireless adapters,

that support Wi-Fi Protected Setup, then you

can use Wi-Fi Protected Setup to automatically

configure wireless security for your wireless

network(s).

To use Wi-Fi Protected Setup, refer to your

wireless adapter’s documentation.

The Wi-Fi Protected Setup button lights up

white and stays on while wireless security is

enabled on your wireless network(s). The button

flashes orange if there is an error during the

Wi-Fi Protected Setup process. Make sure the

client device supports Wi-Fi Protected Setup,

and then try again.

Power (Green/Red) The Power LED lights up

green and stays on while the Router is powered

on. When the Router goes through its self-

diagnostic mode during every boot-up, the LED

will flash. When the diagnostic is complete, it

will be solidly lit green. If the LED lights up red,

make sure the correct power adapter is used.

If the LED remains red, contact your Internet

Service Provider (ISP) or Internet Telephony

Service Provider (ITSP) for support.

Phone 1-2 (Green) The Phone 1 or 2 LED lights

up and stays on when an active line is registered

to the corresponding port on the Router’s back

panel. The LED slowly flashes when voicemail

messages are waiting.

Wireless (Green) The Wireless LED lights up

when the wireless feature is enabled. It flashes

when the Router is actively sending or receiving

data over the network.

Ethernet 1-4 (Green) These numbered LEDs,

corresponding with the numbered ports on the

Router’s back panel, serve two purposes. If the

LED is solidly lit, the Router is connected to a

device through that port. It flashes to indicate

network activity over that port.

Internet (Green) The Internet LED lights up

and stays on when there is a connection made

through the Internet port. It flashes to indicate

network activity over the Internet port.

Back Panel

Internet The Internet port is where you will

connect your cable or DSL Internet connection.

Phone 1-2 The Phone ports connect standard

analog telephones to the Router.

Ethernet 1, 2, 3, 4 These Ethernet ports (1, 2, 3,

4) connect the Router to wired computers and

other Ethernet network devices.

Power The Power port is where you will

connect the power adapter.

1 2 3 4 5 6 7 8 9 10 ... 48 49

Comments to this Manuals

No comments

Cisco WRP400 User's Guide Page 5

Comments to this Manuals

Related products and manuals for Routers Cisco WRP400