Cisco 2600XM Series User Manual download pdf (Page 18)

5 Power Up the Router

Checklist for Power-Up

You are ready to power up the Cisco router after you have completed the following steps:

• Chassis is securely mounted and grounded.

• Power and interface cables are connected.

• Your PC terminal emulation program is configured for 9600 baud, 8 data bits, 1 stop bit, and no parity.

• You have selected passwords for access control.

• You have determined the IP addresses for the Ethernet and serial interfaces.

Front Panel Indicators

The following indicator LEDs provide power, activity, and status information:

• POWER (green)—Lit when power is on

• RPS (green)

–

Off—No redundant power supply (RPS) is present

–

Blinking—System is booted, RPS is present, RPS failure

–

Continuous on—System is booted, RPS is present, no RPS failure

• ACTIVITY (green)

–

Slow, steady blinking—System is booting

–

Blinks during system activity, such as interrupts and packet transfers

Power-Up Procedure

To power up your Cisco router and verify that it goes through its initialization and self-test, perform this procedure. When the

procedure is finished, the Cisco router is ready to configure.

Note To view the boot sequence through a terminal session, you must have a console connection to the Cisco router before

it powers on.

Step 1 Make sure that your PC is powered up and connected as described in the “Checklist for Power-Up” section.

Step 2 Move the power switch to the ON position.

The green POWER or PWR LED on the front of the chassis comes on and the fan operates. If this does not happen, see

the power-up procedure in the Cisco 2600 Series Routers Hardware Installation Guide.

Messages begin to appear in your terminal emulation program window.

Caution Do not press any keys on the keyboard until the messages stop. Any keys pressed during this time are interpreted

as the first command typed when the messages stop, which might cause the router to power off and start over. It

takes a few minutes for the messages to stop.

1 ... 17 18 19 ... 28

No comments

Cisco 2600XM Series User Manual Page 18