Chapter 3 Installing the Cisco XR 12410 Router
Pre-Installation Considerations and Requirements
3-2
Cisco XR 12410 and Cisco XR 12810 Router Installation Guide
OL-17441-01
Pre-Installation Considerations and Requirements
Before you perform any procedures in this chapter, review the following sections
in
Chapter 2, “Preparing for Installation.”
• Safety Guidelines, page 2-2
• Site Requirement Guidelines, page 2-6
In particular, observe the guidelines for preventing electrostatic discharge (ESD)
damage described in the
“Compliance and Safety Information” section on
page 2-3 and use Figure 2-1 on page 2-4 as a reference in locating and using the
ESD sockets on the front of the router chassis.
For additional safety and compliance information, refer to the Regulatory
Compliance and Safety Information for Cisco 12000 Series Routers publication
that accompanied your router.
Warning
This router is not designed to be installed as a shelf-mounted or a free-standing
router. The router must be installed in a rack that is secured to the building
structure. You must install the router in either a telco-style frame or a four-post
equipment rack.
Comments to this Manuals