Cisco UCS-HDD300GI2F208= Datasheet Page 19

  • Download
  • Add to my manuals
  • Print
  • Page
    / 64
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 18
Cisco UCS C240 M3 High-Density Rack Server (Large Form Factor Hard Disk Drive Model)
CONFIGURING the SERVER
19
Approved Configurations
(1) 1-CPU Configurations
Mezzanine cards are not supported for 1-CPU configurations, Therefore, only the following RAID
controllers are supported for single-CPU configurations:
LSI MegaRAID SAS 9266-8i
LSI MegaRAID SAS 9266CV-8i
(2) 2-CPU Configurations
Select a mezzanine card RAID option from Table 5 or one of the RAID controllers from
Table 6. You may also select an appropriate optional RAID configuration listed in Table 6.
Caveats
The mezzanine controller is not available for 1-CPU configurations.
If you choose a mezzanine card RAID controller, all five of the PCIe card slots are still
available for adding optional PCIe cards.
The optional PCIe RAID controllers are all half-height PCIe cards. If you choose one of these
cards, four PCIe card slots will be available for adding an optional PCIe card.
Note that when just one CPU is populated, only a single Cisco UCS P81E or Cisco 1225 Virtual
Interface Card (VIC) card is supported and it must be installed in the full-height PCIe slot
(slot 2) on riser 1. So take this into account when populating RAID controller cards. When
two CPUs are populated, two VIC cards are supported (either the Cisco UCS P81E or Cisco
VIC 1225 or both). One can be installed in slot 2 of riser 1 and one in slot 5 of riser 2. The
primary slot for a VIC card is slot 2. If you have only one of these cards, install it in slot 2.
You can choose only one RAID controller (a plug-in PCIe RAID controller or a mezzanine card
RAID controller).
You can choose an optional RAID configuration (RAID 0, 1, 5, 6, or 10), which is
preconfigured at the factory. The RAID level you choose must be an available RAID choice for
the controller selected. RAID levels 50 and 60 are supported, although they are not available
as configuration options.
NOTE: No RAID option can be chosen if you have no drives
Page view 18
1 ... 18 19 20 ... 64

Comments to this Manuals

No comments