Cisco AM10 User's Guide download pdf (Page 14)

Appendix D: Regulatory Information

FCC Statement

This equipment has been tested and found to comply

with the limits for a Class B digital device, pursuant to Part

15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a

residential installation. This equipment generates, uses

and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause

harmful interference to radio communications. However,

there is no guarantee that interference will not occur in

a particular installation. If this equipment does cause

harmful interference to radio or television reception,

which can be determined by turning the equipment

off and on, the user is encouraged to try to correct the

interference by one of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and

receiver.

• Connect the equipment into an outlet on a circuit

different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV

technician for help.

FCC Caution: Any changes or modifications not expressly

approved by the party responsible for compliance could

void the user’s authority to operate this equipment.

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions: (1)

This device may not cause harmful interference, and (2) this

device must accept any interference received, including

interference that may cause undesired operation.

The availability of some specific channels and/or

operational frequency bands are country dependent

and are firmware programmed at the factory to match

the intended destination. The firmware setting is not

accessible by the end user.

FCC Radiation Exposure Statement

This equipment complies with FCC radiation exposure

limits set forth for an uncontrolled environment. End users

must follow the specific operating instructions for satisfying

RF exposure compliance. To maintain compliance with

FCC RF exposure compliance requirements, please follow

operation instructions as documented in this manual.

This transmitter must not be co-located or operating in

conjunction with any other antenna or transmitter.

SAR compliance has been established in typical laptop

computer(s) with USB slot, and this product could be

used in typical laptop computer(s) with USB slot. Other

applications like handheld PC or similar device have not

been verified and may not be in compliance with related

RF exposure rule and such use shall be prohibited.

Safety Notices

WARNING: Do not use this product near water,

for example, in a wet basement or near a

swimming pool.

WARNING: Avoid using this product during an

electrical storm. There may be a remote risk of

electric shock from lightning.

WARNING: This product contains lead, known

to the State of California to cause cancer, and

birth defects or other reproductive harm. Wash

hands after handling.

WARNING: For use with a Listed Computer.

1 ... 13 14 15 ... 31

Comments to this Manuals

No comments

Cisco AM10 User's Guide Page 14

Comments to this Manuals

Related products and manuals for Networking cards Cisco AM10