Cisco 4510R - Catalyst Switch User Manual download pdf (Page 6)

Mode = Duplex

!−−− Indicates secondary is present and in redundant state.

Unit = Primary

!−−− Always is primary because this is RPR mode.

Unit ID = 2

!−−− Slot number of active.

Redundancy Mode (Operational) = RPR

!−−− Indicates redundancy mode.

Redundancy Mode (Configured) = RPR

Split Mode = Disabled

Manual Swact = Enabled

Communications = Up

client count = 4

client_notification_TMR = 60000 milliseconds

keep_alive TMR = 9000 milliseconds

keep_alive count = 0

keep_alive threshold = 18

RF debug mask = 0x0

If the standby module is not operational because it is in ROMmon or other reasons, or it is not

present, this output displays:

Switch#show redundancy states

my state = 13 −ACTIVE

peer state = 1 −DISABLED

!−−− Standby supervisor is not up or not present.

Mode = Simplex

!−−− Not redundant.

Unit = Primary

Unit ID = 2

Redundancy Mode (Operational) = RPR

Redundancy Mode (Configured) = RPR

Split Mode = Disabled

Manual Swact = Disabled Reason: Simplex mode

Communications = Down Reason: Simplex mode

client count = 4

client_notification_TMR = 60000 milliseconds

keep_alive TMR = 9000 milliseconds

keep_alive count = 0

keep_alive threshold = 18

RF debug mask = 0x0

Manual Switchover Commands

These commands can be used to perform manual switchover or power−cycle of the supervisor:

reloadThis reloads the current active supervisor in order to perform a switchover to the standby.•

1 2 3 4 5 6 7 8 9 10 11 ... 20 21

No comments

Cisco 4510R - Catalyst Switch User Manual Page 6