Cisco Aironet 1000 Series Specifications download pdf (Page 15)

Installation and Configuration

Pre-Installation Configuration

AP1020/1030 Cisco Aironet 1000 Series IEEE 802.11a/b/g Lightweight Access Points with External Antennas - Quick Start Guide

78-17147-01

Pre-Installation Configuration

The following procedures are designed to ensure that your Cisco Aironet 1000 Series lightweight access

point physical installation and that initial operation goes as expected. If you are unable to prepare your

Cisco Aironet 1000 Series lightweight access point for deployment, this step also describes RMA

(Return Material Authorization) procedures.

Perform the following procedure on each Cisco Aironet 1000 Series lightweight access point BEFORE

deploying it in its final location.

• Preparing a Version 3.0 Cisco Aironet 1000 Series Lightweight Access Point OR

• Alternate Method of Preparing a Version 3.0 Cisco Aironet 1000 Series Lightweight Access Point

for installation in a Version 3.0 deployment

If you are unable to perform the following procedure, refer to the “Obtaining Technical Assistance”

section.

Preparing a Version 3.0 Cisco Aironet 1000 Series Lightweight Access Point

If your Cisco Aironet 1000 Series lightweight access point has Operating System 3.0 or a later version

loaded on it, continue with this procedure.

Note This procedure is written assuming that you are preparing a version 3.0 Cisco Aironet 1000 Series

lightweight access point to operate with a Cisco Wireless LAN Controller.

Configuration Setup

Figure 4 Configuration Setup

Appliance

Layer 2/3

devices

Switch

135675

APs and REAPs

Appliance mode Direct-connect

mode

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 43 44

No comments

Cisco Aironet 1000 Series Specifications Page 15