Cisco Aironet 1000 Series Specifications download pdf (Page 23)

Installation and Configuration

Preparing Mounting Locations

AP1020/1030 Cisco Aironet 1000 Series IEEE 802.11a/b/g Lightweight Access Points with External Antennas - Quick Start Guide

78-17147-01

Figure 7 Factory-Orderable Mounting Brackets

If necessary, drill holes for the various cables where they can be mostly hidden from casual view.

When you are mounting the Cisco Aironet 1000 Series lightweight access point using an optional

orderable projection-mount L-bracket (the one with two long legs), the cables can be routed through

the 5/8-in. (15.9 mm) holes in the bracket.

3. Route the CAT-5, optional power supply, optional external antenna cable(s), and optional

Kensington MicroSaver Security cables to where they can plug into the Cisco Aironet 1000 Series

lightweight access point. Be sure to leave about 6 in. (15 cm) of slack in the cables for future

modifications.

4. Attach the brackets to the wall or ceiling, or install screws for ceiling-mount base:

–

Where you are going to use the projection-mount or flush-mount bracket, use customer-supplied

sheet metal, drywall, or other screws to attach the bracket to the ceiling or wall.

–

Where you are going to use the ceiling-mount base, install customer-supplied sheet metal,

drywall, or other screws with 1/4 in. (6.35 mm) or smaller heads protruding from the ceiling

about 0.1 in. (2.5 mm).

You are now ready to install the Cisco Aironet 1000 Series 802.11a/b/g lightweight access points.

Continue with “Mounting the Cisco Aironet 1000 Series Lightweight Access Points.”

135661

A. Projection-mount bracket

B. Flush-mount bracket

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 43 44

No comments

Cisco Aironet 1000 Series Specifications Page 23