Cisco Ethernet switch Operations Instructions download pdf (Page 167)

Chapter 7. Cisco Systems IGESM configuration and network integration 153

Step-by-step instructions to configure BladeServer4

Table 7-14 shows the step-by-step instructions used to configure BladeServer4.

Table 7-14 Configuring BladeServer4 for 802.1Q trunks with multiple VLANs and SLB

Step 4.3.5:

Configure desired IP address on

each VLAN

This step assumes that the user knows how

to add IP addressing information.

Note that the default gateway used is part of

the base HSRP config of the 6500s.

Also note that on production systems, you

would normally configure one or more DNS

servers. This was not included as part of this

environment but should be included in most

production networks.

For this step, attempting to apply IP

addressing directly onto a physical interface

is not supported.

1. From Windows, click Start → Settings → Network and Dial-up

Connections.

You should now see the original physical network interfaces along with

the new logical interface.

2. Select the ToCIGESM1/ToBoth-VLAN30 interface and configure

the IP address as follows:

– IP Address: 10.1.30.3

– Mask: 255.255.255.0

– Default Gateway: 10.1.30.254

Description and comments On BladeServer3

BASP using VLANs on both Ethernet ports for SLB

Description and comments On BladeServer4

BASP using teaming and VLANs on both Ethernet ports

Step 4.4.1:

Launch BASP software.

This step assumes that the desired software

is already installed.

Click Start → Programs → Broadcom → Broadcom Advanced

Control Suite.

This assumes that the software used a default installation. You can also

launch this software through an icon in the lower-right corner of the

window near the clock (move your cursor until you find the icon labeled

“Control Suite”).

Step 4.4.2:

Create and name the team.1.Click Tools → Create a Team on the toolbar.

2. Enter ToBoth-Trunked in the name field and click Next.

3. Select the first NIC on the left side of the window and click the top

right pointing arrow to add this NIC to the Load Balance Members.

4. Select the second NIC on the left side of the window and click the

top right pointing arrow to add this NIC to the Load Balance

Members.

5. Click Finish.

Step 4.4.3:

Create desired VLANs on Team

ToBoth-Trunked

Create and name VLANs 35, 40, 45, and 50

to the team ToBoth-Trunked.

1. Click Tools → Configure a Team on the toolbar.

Because there is only a single team, the BASP software takes you

straight into the Team Configuration page.

2. Click Add VLAN button on right side of window.

3. In the VLAN ID field, enter 35.

4. In the VLAN Name field, enter VLAN35.

Note that the names should be descriptive but can be anything you

prefer. Also note that you want to leave the box labeled Untagged

VLAN cleared.

5. Click OK to create this VLAN.

Repeat step 4.4.3a for the remaining VLANs on this team. Set the values

as follows:

– VLAN ID to 40, and name it VLAN40.

– VLAN ID to 45, and name it VLAN45.

– VLAN ID to 50, and name it VLAN50.

1 ... 166 167 168 ... 266

Comments to this Manuals

No comments

Cisco Ethernet switch Operations Instructions Page 167

Comments to this Manuals

Related products and manuals for Networking Cisco Ethernet switch