Cisco MWR-1900-27 Specifications download pdf (Page 484)

100

101

B-248

Cisco MWR 2941 Mobile Wireless Edge Router Software Configuration Guide, Release 12.2(33)MRB

OL-21227-02

Appendix B Cisco MWR 2941 Router Command Reference

network-clock-select hold-off-timeout

Determines that the time in milliseconds that the Cisco MWR 2941 waits when a synchronous Ethernet

clock source fails before taking action. After the holdoff timer expires, the router announces the failure

and takes one of the following actions depending on the clocking configuration:

• Considers other clock sources

• Switches to holdover mode—The router generates a timing signal based on the stored timing

reference.

The network-clock-select hold-timeout command specifies how long the router waits before

reevaluating the network clock entry. To remove a network-clock-select hold-off-timeout

configuration, use the no form of this command.

network-clock-select hold-timeout duration

no network-clock-select hold-timeout duration

Syntax Description

Command Default The default setting is network-clock-select hold-timeout infinite.

Command Modes Global configuration

Command History

Usage Guidelines The holdoff timer is a global timer value; it applies to both synchronous Ethernet clock sources when

configured.

Examples The following example shows how to use the network-clock-select command:

Router# config t

Router(config)# network-clock-select hold-timeout 2000

Router(config)# exit

Related Commands

duration Valid values are 0 or 50–10000

Release Modification

12.2(33)MRA This command was introduced.

Command Description

set network-clocks

force-reselect

Forces the router to re-select the network clock.

1 2 ... 479 480 481 482 483 484 485 486 487 488 489 ... 813 814

Comments to this Manuals

No comments

Cisco MWR-1900-27 Specifications Page 484

Comments to this Manuals

Related products and manuals for Networking Cisco MWR-1900-27