Cisco PA-T3 Specifications download pdf (Page 38)

Installing a Port Adapter

PA-T3 Serial Port Adapter Installation and Configuration

5-4

Step 5 With the metal carrier aligned in the slot guides, gently slide the port adapter halfway into

the slot.

Caution Do not slide the port adapter all the way into the slot until you have connected all required cables.

Trying to do so disrupts normal operation of the router.

Step 6 With the port adapter halfway in the slot, connect all required cables to the port adapter.

Step 7 After connecting all required cables, carefully slide the port adapter all the way into the

slot until the port adapter is seated in the router midplane.

Step 8 After seating the port adapter in the router midplane, move the port adapter lever to the

locked position. Figure 5-5 shows the port adapter lever in the locked position.

Note If the port adapter lever does not move to the locked position, the port adapter is

not completely seated in the midplane. Carefully pull the port adapter halfway out of the

slot, reinsert it, and move the port adapter lever to the locked position.

Figure 5-5 Placing the Port Adapter Lever in the Locked Position—Cisco 7206 Shown

This completes the procedure for installing a new port adapter in a Cisco 7200 series router. Proceed

to Chapter 8, “Conﬁguring the PA-T3 Interfaces,” for information on how to conﬁgure your port

adapter interfaces.

ETHERNET 10BT

ENABLED

LINK

FAST SERIAL

ENABLED

MII

LINK

RJ45

FAST ETHERNET

TOKEN RING

H6747

MII

RJ45

LINK

1O PWR

RJ-45

CPU RESET

FAST ETHERNET INPUT/OUTPUT CONTROLLER

ENABLED

PCMCIA

EJECT

SLOT 0

SLOT 1

FE MII

Port adapter

handle

Port adapter

lever (locked

position)

Note: This adapter installation

applies to any port or service

adapter.

1 ... 37 38 39 ... 74

Comments to this Manuals

No comments

Cisco PA-T3 Specifications Page 38

Comments to this Manuals

Related products and manuals for Networking Cisco PA-T3